Meter, gauge and indication/ warning lamp operation
Run the engine to check the operation of all meters, gauges, and indication/warning lamps.
If there is anything wrong, take the vehicle to an authorized MITSUBISHI dealer for inspection.
See also:
Gearshift lever positions (Manual shift gate)
“P” PARK
This position locks the transmission to prevent the vehicle from moving. The
engine can be started in this position.
“R” REVERSE
This position is to back up.
Caution
► N ...
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
...
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v ...