Lamp monitor buzzerLamp monitor buzzer  - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

[When the engine was started using the key]

If the driver’s door is opened when the key is in the “LOCK” or “ACC” position or removed from the ignition switch while the lamps are on, a buzzer will sound to remind the driver to turn off the lamps.

[When the engine was started using the keyless operation function]

If the driver’s door is opened when the operation mode is in ACC or OFF with the lamps illuminated, a buzzer will sound to remind the driver to turn off the lamps.

In both cases, the buzzer will automatically stop if the auto-cutoff function is activated, the lamp switch is turned off, or the door is closed.

    See also:

    Rear fog lamp
    1. Remove the socket and bulb assembly by turning it anticlockwise. 2. Remove the bulb by pulling it out. 3. To install the bulb, perform the removal steps in reverse. ...

    To remove the spare tyre
    1. Lift up the board. 2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise. Note ► Put the spare wheel under the vehicle body near the jack. This make ...

    Fuse block
    To prevent damage to the electric system due to short-circuiting or overloading, each individual circuit is provided with a fuse. There are fuse boxes in the passenger compartment and in the eng ...