To unlock
Press the UNLOCK switch (2). All the doors and the rear hatch will be unlocked. If the front room lamp switch (if so equipped) is in the “DOOR” position and the rear room lamp switch (except for vehicles equipped with the sunroof) is in the middle (•) position at this time, the room lamp will come on for approximately 15 seconds and the turn-signal lamps will blink twice.
Except for vehicles for Russia, Kazakhstan and Ukraine, the position and tail lamps can also be set to turn on for about 30 seconds.
Refer to “Instruments and controls: Welcome light”.
Note
► For vehicles equipped with the central door lock switch, the door and rear hatch unlock function can be set so that only the driver’s door unlocks when the UNLOCK switch (2) is pressed once.
If the door and rear hatch unlock function is set to work as described above, all the doors and the rear hatch unlock when the UNLOCK switch is pressed two times in succession.
Refer to “Setting of door and rear hatch unlock function”.
► The indication lamp (3) comes on each time a switch is pressed.
► For vehicles with the mirror retractor switch, the outside rear-view mirrors automatically retract or extend when all doors and the rear hatch are locked or unlocked using the remote control switches of the keyless entry system.
Refer to “Outside rear-view mirrors”.
► If the UNLOCK switch (2) is pressed and no door or rear hatch is opened within approximately 30 seconds, relocking will automatically occur.
► It is possible to modify functions as follows: For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
• The time for automatic relocking can be changed.
• Activating the operation confirmation function (blinking of the turn-signal lamps)
only during locking, or only during unlocking.
• The confirmation function (this indicates locking or unlocking of the doors and
rear hatch with the turn-signal lamps blinking) can be deactivated.
• The number of times the turn-signal lamps are flashed by the confirmation function
can be changed.
See also:
Folding the seat (Hatchback)
1. Remove the rear shelf panel and rear head restraints. Refer to the description
of “Rear shelf panel” on page NO TAG and “Head restraints” on page 3–7.
2. Pull the band (between the ...
Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)
Do not attempt to disassemble or repair headlamps, and do not attempt to replace
their bulbs.
Warning
► A high voltage is present in the power circuit and in the bulbs and bulb
terminals. ...
Introduction of outside air
To introduce air into the vehicle during hot weather, set the air selection switch
(A) to the outside position and set the temperature control dial to the position
shown in the illustration. Be ...
