Modification/alterations to the electrical or fuel systems
MITSUBISHI MOTORS CORPORATION has always manufactured safe, high quality vehicles. In order to maintain this safety and quality, it is important that any accessory that is to be fitted, or any modifications carried out which involve the electrical or fuel systems, should be carried out in accordance with MITSUBISHI guidelines.
Caution
► If the wiring interferes with any part of the vehicle bodywork or improper installation methods are used, i.e. protective fuses not installed, etc.), electronic devices may be adversely affected, possibly resulting in an electrical fire or other failures that may cause an accident.
See also:
Headlamps (low beam, except for vehicles with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v ...
Rear fog lamp
1. Remove the socket and bulb assembly by turning it anticlockwise.
2. Remove the bulb by pulling it out.
3. To install the bulb, perform the removal steps in reverse. ...
Outside temperature display screen
This shows the temperature outside the vehicle.
NOTE
• The display setting can be changed to the preferred units (°C or °F).
Refer to “Changing the function settings (when the ignition swi ...
