Activation
The Auto Stop & Go (AS&G) system is automatically activated when the ignition switch is turned to the “ON” position.
See also:
Loading a roof carrier
Caution
► Use a roof carrier that properly fits your vehicle.
Do not load luggage directly onto the roof.
For installation, refer to the instruction manual accompanying the roof carrier.
N ...
Setting the system
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key from the ignition
switch.
2. Get out of the vehicle. Close all doors and rear ha ...
To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.
Note
► Put the spare wheel under the vehicle body near the jack. This make ...