Caution for installing the child restraint on vehicles with a front passenger airbagCaution for installing the child restraint on vehicles with a front passenger airbag - Child restraint - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Seat and seat belts / Child restraint / Caution for installing the child restraint on vehicles with a front passenger airbag

The label shown here is attached on vehicles with a front passenger airbag.

Warning

► Extreme Hazard! Warning

► Extreme Hazard!
Do not use a rearward facing child restraint on a seat protected by an airbag in front of it!

Use rearward facing child restraints in the rear seat or turn off the front passenger’s airbag ON-OFF switch (if so equipped). (Refer to “To turn an airbag off”.)

Warning

► A REARWARD FACING CHILD RESTRAINT must NOT be used in the front passenger Warning

► A REARWARD FACING CHILD RESTRAINT must NOT be used in the front passenger seat if the front passenger’s airbag has not been deactivated. The force of an inflating airbag could kill or cause serious injuries to the child. A rearward facing child restraint must only be used in the rear seat.
► A FORWARD FACING CHILD RESTRAINT should be used in the rear seat whenever possible; if used in the front seat, adjust the seat to the most rearward position.

Infants and small children

    See also:

    Installing a child restraint system to the lower anchorage (ISOFIX child restraint mountings) and tether anchorage
    Lower anchorage location Your vehicle’s rear seat is fitted with lower anchorages for attaching a child restraint system with ISOFIX mountings. Tether anchorage locations There are 2 child re ...

    Bonnet
    To open Pull the release lever towards you to unlock the bonnet. Raise the bonnet while pressing the safety lock. NOTE Only open the bonnet when the wipers are in the parked position. Failure ...

    To operate
    To operate the system, move the gearshift lever or selector lever to the “R” position while the ignition switch is in the “ON” position. When the reversing sensor system is operated, the r ...