Operation of the Dead Lock System
In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.)
See also:
Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box ...
Change of the blower speed
Adjust the blower speed by turning the blower speed selection dial clockwise
or anticlockwise.
The blower speed will gradually increase as the dial is turned to the right.
Blower speed indicat ...
Starting and stopping the
Tips for starting
• The operation mode can be in any mode to start the engine.
• The starter motor will be turning for up to approximately 15 seconds if the
engine switch is released at once ...