To unlockTo unlock  - Keyless entry system - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Press the UNLOCK switch (2). All the doors and the rear hatch will be unlocked. If the front room lamp switch (if so equipped) is in the “DOOR” position or the rear room lamp switch (except for vehicles equipped with the sunroof) is in the middle (•) position at this time, the room lamp will come on for approximately 15 seconds and the turn-signal lamps will blink twice.

Except for vehicles for Russia, Kazakhstan and Ukraine, the position and tail lamps can also be set to turn on for about 30 seconds.

Refer to “Instruments and controls: Welcome light”.

► For vehicles equipped with the central door lock switch, the door and rear Note

► For vehicles equipped with the central door lock switch, the door and rear hatch unlock function can be set so that only the driver’s door unlocks when the UNLOCK switch (2) is pressed once.

If the door and rear hatch unlock function is set to work as described above, all the doors and the rear hatch unlock when the UNLOCK switch is pressed two times in succession.

Refer to “Setting of door and rear hatch unlock function”.

    See also:

    Wheel covers
    To removeWrap the tip of the jack bar with a cloth, insert it deeply into the notch provided in the wheel cover, and pry the cover away from the wheel. Using the same procedure at the other wheel ...

    Demisting of the windscreen and door windows
    CAUTION For safety, make sure you have a clear view through all windows. To remove frost or mist from the windscreen and door windows, use the mode selection dial (“” or “”). - To ke ...

    Position lamps (for vehicles equipped with high intensity discharge headlamps)
    1. To create enough work space, turn the steering wheel all the way in the direction opposite to the side you wish to replace. 2. Remove the clips (A) and screws (B) to turn up the cover (C). ...