Mark display screen (when the ignition switch is “OFF”)Mark display screen (when the ignition switch is “OFF”) - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Instruments and controls / Multi-information display / Mark display screen (when the ignition switch is “OFF”)

If you press the multi-information meter switch and return from the warning display

If you press the multi-information meter switch and return from the warning display screen to the previous screen, the mark is displayed.

Refer to “To return to the screen displayed before the warning” on page.

This mark is also displayed if there is another warning other than the one displayed.

When the cause of the warning display is eliminated, the mark goes out automatically.

► When the mark is displayed, the warning display screen can be redisplayed on Note

► When the mark is displayed, the warning display screen can be redisplayed on the information screen.
Refer to “Information screen (when the ignition switch is “OFF“)”.
Refer to “Information screen (when the ignition switch is “ON”)”.

    See also:

    Handling of compact discs
    • Use only the type of compact discs that have the mark shown in the illustration below. (Playback of CD-R or CD-RW discs may cause problems.) • The use of special shaped, damaged compact di ...

    Front room & map lamps
    1 (DOOR) - The lamp illuminates when a door or the rear hatch is opened. It goes off about 15 seconds after the door or rear hatch is closed. However, the lamp goes off immediately in the follow ...

    To reduce the set speed
    There are 2 ways to reduce the set speed. Auto–speed control lever Pull down and hold the auto–speed control lever until you reach the lower speed you want. Release the lever when the desire ...