Parking
To park the vehicle, fully engage the parking brake, and then move the gearshift lever to 1st or “R” (Reverse) position for vehicles equipped with M/T, or set the selector lever (CVT) or gearshift lever (Twin Clutch SST) to “P” (PARK) position for vehicles equipped with a CVT or Twin Clutch SST.
See also:
Starting
Tips for starting
• Do not operate the starter motor continuously longer than 10 seconds; doing
so could run down the battery. If the engine does not start, turn the ignition switch
back to “ ...
Operating the heater system
Heating
Set the mode selection dial to the
position and set the air selection
switch (A) to the outside position.
Turn the temperature control dial clockwise or anticlockwise to the desired temp ...
SRS servicing
Warning
► We recommend any maintenance performed on or near the components of the
SRS to be performed by a MITSUBISHI MOTORS Authorized Service Point.
Improper work on the SRS components or ...