Retracting and extending the mirrors without using the mirror retractor switchRetracting and extending the mirrors without using the mirror retractor switch  - Retracting and extending the outside mirrors - Outside rear-view mirrors - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

[Vehicles with keyless entry system] The mirrors automatically retract or extend when the doors are locked or unlocked using the remote control switches of the keyless entry system. Refer to “Keyless entry system”.

[Vehicles with keyless operation system] The mirrors automatically retract or extend when the doors are locked or unlocked using the remote control switches or the keyless operation function of the keyless operation system. Refer to “Keyless operation system: To operate using the keyless operation function, Keyless entry system” on pages 1-09 and 1-04.

► Functions can be modified as stated below. Note

► Functions can be modified as stated below.
Consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.
• Automatically extend when the ignition switch is turned to the “ON” position, and automatically retract when the driver’s door is opened after the ignition switch is turned to the “OFF” position.
• Automatically extend when the vehicle speed reaches 30 km/h (19 mph).
• Deactivate the automatic extension function.

    See also:

    A/T mode changeover switch (Except for vehicles with Sports mode)
    Two drive modes, “AUTO” and “HOLD”, can be selected. Each time you press the switch, the “AUTO” and “HOLD” modes will switch alternately. When the “HOLD” mode is selected, the ...

    Windscreen washer
    The windscreen washer can be operated with the ignition switch or the operation mode in ON or ACC. The washer fluid will be sprayed onto the windscreen by pulling the lever towards you. When the ...

    Front turn-signal lamps
    1. Remove the clips (A) and clips (B), then remove the duct (C) and the upper cover (D). 2. Remove the entire socket and bulb assembly (E) by turning it anticlockwise. : Front of the vehicle ...