ACC power auto-cutout function
After about 30 minutes has elapsed with the ignition switch in the “ACC” position, the function automatically cuts out the power for the audio system and other electric devices that can be operated with that position.
When the ignition switch is turned from the “ACC” position, the power is supplied again to those devices.
Note
► It is possible to modify functions as follows:
• The time until the power cuts out can be changed to approximately 60 minutes.
• The ACC power auto-cutout function can be deactivated.
For details, we recommend you to consult a MITSUBISHI MOTORS Authorized Service
Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations
can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Brake fluid
Check the brake fluid level in the reservoir. The brake fluid level must be between
the “MAX” and “MIN” marks on the reservoir. The fluid level falls slightly with
wear of the brake pads ...
Twin Clutch SST control mode
When the ignition switch is set to the “ON” position, operate the Twin Clutch
SST control mode switch (A) to change the control mode.
When the engine is started, the control mode is automatic ...
Interrupt display screen (when the ignition switch or the operation mode is
OFF)
When there is information to be announced, such as lamp reminders, the buzzer
sounds and the multiinformation display switches to the warning display screen.
Refer to the appropriate page and take ...