If the display/indicator blinks while driving
If the
display/indicator blinks, the
Auto Stop & Go (AS&G) system is malfunctioning and will not operate.
We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
See also:
Inspection and maintenance following rough road operation
After operating the vehicle in rough road conditions, be sure to perform the
following inspection and maintenance procedures:
• Check that the vehicle has not been damaged by rocks, gravel, etc.
...
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towing bar, you can change
the reversing sensor system between the standard mode and the towing bar mode. The
towing bar mode changes the system ...
Front room & map lamps
When replacing the bulb, put the front room & map lamps switch into the “OFF”
position.
1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into
the notch of the l ...