Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system
or keyless operation system)
If any of the interior lamps are left switched on with the ignition switch in any position other than “ON” or “ACC”, it goes off automatically after approximately 30 minutes.
The lamp goes on again if the ignition switch is turned to the “ON” or “ACC” position, any door or the rear hatch is opened and closed, or the keyless entry remote control or the keyless operation system is operated.
Note
► The interior lamps auto-cutout function can be deactivated. The time until the lamps automatically go off can be adjusted. For details, please consult a MITSUBISHI MOTORS Authorized Service Point.
If the vehicle is equipped with the MITSUBISHI Multi-Communication System (MMCS), adjustment can be made using screen operations. Refer to the separate owner’s manual for details.
See also:
To fasten
1. Pull the seat belt out slowly while holding the latch plate.
Note
► When the seat belts cannot be pulled out in a locked condition, pull the belts
once forcefully and then return them. A ...
Operating a music player connected via Bluetooth®
For the operation of a music player connected via Bluetooth®, refer to “To play
tracks from a Bluetooth ® device”. ...
To increase the set speed
There are 2 ways to increase the set speed.
“ACC RES” switch
Press and hold the “ACC RES” switch (C) while driving at the set speed, and your
speed will then gradually increase.
When you ...
