To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.

Note
► Put the spare wheel under the vehicle body near the jack. This makes it safer if the jack slips out of position.

See also:
Operation of the Dead Lock System
In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock
System using the remote controller.
(Refer to “Dead Lock System”.) ...
How to enter frequencies in the memory
Manual setting
You can assign to the memory select buttons (8) a maximum of 12 stations in the
UKW band (6 U1 stations and 6 U2 stations), 6 stations in the MW band and 6 stations
in the LW ban ...
Information screen (when the ignition switch is turned from the “LOCK”
position to
the “ON” position or the operation mode is changed from OFF to
ON)
When the ignition switch is turned to the “ON” position or the operation mode
is put in ON, the display screen switches in the following order.
1- Screen when the ignition switch or the opera ...
