Petrol-powered vehicles with turbochargePetrol-powered vehicles with turbocharge - Selection of engine oil - Engine oil - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► Select engine oil of the proper SAE viscosity number according to the atmospheric

► Select engine oil of the proper SAE viscosity number according to the atmospheric temperature.

SAE 5W-30, 0W-30 and 0W-40 engine oil can only be used if it meets ACEA A3/B3, A3/B4 or A5/B5 and API SM or higher specifications.

► SAE 0W-30 and 0W-40 engine oil are recommended to use to improve engine startability on a very cold weather condition.

► Use engine oil conforming to the following classification: • API classification: “For service SM” or higher
• ILSAC certificated oil
• ACEA classification:
“For service A1/B1, A3/B3, A3/B4 or A5/B5”

► Use of additives is not recommended since they may reduce the effectiveness Note

► Use of additives is not recommended since they may reduce the effectiveness of additives already included in the engine oil. It may result in failure of the mechanical assembly.

    See also:

    Average speed
    For vehicles with MITSUBISHI genuine audio, average speed can be displayed. This value shows the average speed (in km/h or mph) since the display was reset. If you reset the display at the time ...

    Corner and back sensor locations
    There are two corner sensors (A) at the corners of the rear bumper, and two back sensors (B) in the centre of the rear bumper. ...

    Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped with high intensity discharge headlamps)
    1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2 ...