Installation of accessoriesInstallation of accessories  - General information - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

We recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.

• The installation of accessories, optional parts, etc., should only be carried out within the limits prescribed by law in your country, and in accordance with the guidelines and warnings contained within the documents accompanying this vehicle.

• Installing electric components incorrectly could lead to a fire. Please refer to Modification/ alteration to the electrical or fuel systems section within this owner’s manual.

• Using a cellular phone or radio set inside the vehicle without an external antenna may cause electrical system interference, which could lead to unsafe vehicle operation.

• Tyres and wheels which do not meet specifications must not be used.

Refer to the “Specifications” section for information regarding wheel and tyre sizes.

Important points!

Due to large number of accessory and replacement parts of different manufactures available in the market, it is not possible, not only for MITSUBISHI MOTORS, but also for a MITSUBISHI MOTORS Authorized Service Point, to check whether the attachment or installation of such parts affects the overall safety of your MITSUBISHI-vehicle.

Even when such parts are officially authorized, for example by a “general operators permit” (an appraisal for the part) or through the execution of the part in an officially approved manner of construction, or when a single operation permit following the attachment or installation of such parts, it cannot be deduced from that alone, that the driving safety of your vehicle has not been affected.

Consider also that there basically exists no liability on the part of the appraiser or the official. Maximum safety can only be ensured with parts recommended, sold and fitted or installed by a MITSUBISHI MOTORS Authorized Service Point (MITSUBISHI MOTORS genuine replacement parts and MITSUBISHI MOTORS accessories).

The same also pertains to modifications of MITSUBISHI vehicles with respect to the production specifications. For safety reasons, do not attempt any modifications other than those that follow the recommendations of a MITSUBISHI MOTORS Authorized Service Point.

    See also:

    Cancelling the alarm
    It is possible to halt the activation of an alarm using the following methods: • Pressing the LOCK or UNLOCK switch on the remote control switch. (After pressing the LOCK switch, the vehicle will ...

    Safety
    The Insurance Institute for Highway Safety gave the Outlander Good overall scores, the highest rating possible, in its frontal-offset and side-impact crash tests. It received an Acceptable rating ...

    Anti-theft lock
    The anti-theft lock is located on the top of the rear seatback. The cylinder is operated with the master key (A). When the lock is in the “LOCK” position, the seatback cannot be folded down b ...