Hazard warning flasher switchHazard warning flasher switch - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

Use the hazard warning flasher switch when the vehicle has to be parked on the road for any emergency.

The hazard warning flashers can always be operated, regardless of the ignition switch position or the operation mode.

Push the switch to turn on the hazard warning flashers, all turn-signal lamps flash continuously. To turn them off, push the switch again.

NOTE

• While the hazard warning lamps are blinking due to having manually pushed the NOTE

• While the hazard warning lamps are blinking due to having manually pushed the switch, the emergency stop signal system does not operate.

Refer to “Emergency stop signal system”.

    See also:

    Starting the engine (petrol-powered vehicles)
    The starting procedure is as follows: 1. Fasten the seat belt. 2. Make sure the parking brake is applied. 3. Depress and hold the brake pedal. 4. Fully depress the clutch pedal. (M/T) Note υ ...

    Instruments
    1- Fuel gauge 2- Speedometer 3- Tachometer* 4- Water temperature gauge 5- Tripmeter reset button 6- Tripmeter 7- Odometer ...

    System cancellation
    It is possible to cancel the system activation during the system preparation mode or the system armed mode. In addition, it is possible to cancel the alarm once it has been activated. Refer to “ ...