Windscreen washer
The windscreen washer can be operated with the ignition switch or the operation mode in ON or ACC.
The washer fluid will be sprayed onto the windscreen by pulling the lever towards you.
When the wipers are not in operation or in intermittent operation, by pulling the lever towards you, the wipers will operate several times while the washer fluid is being sprayed.
Except for vehicles for Russia, Kazakhstan and Ukraine, then about 6 seconds later, wipers operate once more.
On vehicles equipped with a headlamp washer, while the headlamps are on, the headlamp washer will operate once together with the windscreen washer.
Also, except for vehicles for Russia, Kazakhstan and Ukraine, by releasing the lever soon after pulling it towards you, the washer fluids will be sprayed several times while the wipers are operating several times. (Comfort washer) Then about 6 seconds later, wipers operate once more.
Comfort washer will stop operating with any operation of the lever.
CAUTION
• If the washer is used in cold weather, the washer fluid sprayed against the glass may freeze resulting in poor visibility.
Heat the glass with the defroster or demister before using the washer.
NOTE
• It is possible to modify functions as follows:
• Causing the wiper never to operate when washer fluid is sprayed.
• Except for vehicles for Russia, Kazakhstan and Ukraine, deactivating the comfort
washer.
• Except for vehicles for Russia, Kazakhstan and Ukraine, deactivating the function
that operates the wipers once more about 6 seconds later.
• Vehicles for Russia, Kazakhstan and Ukraine, activating the comfort washer.
• Vehicles for Russia, Kazakhstan and Ukraine, the wipers can be set to operate
again after about 6 seconds.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Accessory socket
CAUTION
• Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W
or less.
When using more than one socket at the same time, make sure that the electrical
accessories are ...
When turning from “LOCK” to “ACC”
1. Take the emergency key out of the keyless operation key. Refer to “Emergency
key”.
2. Remove the ignition switch cover while pressing the lock release button (A).
3. Insert the emergency ...
Engine compartment
Clean the engine compartment at the beginning and end of winter. Pay particular
attention to flanges, crevices and peripheral parts where dust containing road chemicals
and other corrosive materia ...