Warning lamp

The ABS warning lamp should illuminate when the ignition switch is turned ”ON”, and should go off in a few seconds.
CAUTION
If the warning lamp stays on or does not illuminate when you start the vehicle, it indicates that the ABS is not functioning and that only the standard brake system is in operation. (In this condition the standard hydraulic brake system will still function.) Please contact your nearest authorized MITSUBISHI dealer for inspection.
See also:
Jacking up 4-wheel drive vehicles
Warning
► Do not crank the engine while jacking up the vehicle.
The tyre on the ground may turn and the vehicle may roll off the jack. ...
Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system
or keyless operation system)
If any of the interior lamps are left switched on with the ignition switch in
any position other than “ON” or “ACC”, it goes off automatically after approximately
30 minutes.
The lamp goe ...
Possible driving speed
Avoid shifting down at high speed, as this may cause excessive engine speed (the
tachometer needle into the red zone) and damage the engine.
Petrol-powered vehicles without MIVEC engine
Use 5 th ...
