Type 2 (Except for vehicles equipped with the central door lock switch)
Note
► Each of the doors can be locked or unlocked independently by using the inside lock knob (except for the driver’s door).
► Repeated continuous operation between lock and unlock could activate the central door locking systems built-in protection circuit and prevent the system from operating. If this occurs, wait about 1 minute before operating the inside lock knob or the key.
See also:
Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob (A) depressed. To move the
anchor up, slide it without depressing the lock knob (A).
Warning
` ...
Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignitio ...
Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly.
If the lamps do not illuminate, the probable cause is a blown fuse or defective
lamp bulb. Check the fuses fir ...