To fasten
1. Pull the seat belt out slowly while holding the latch plate.
Note
► When the seat belts cannot be pulled out in a locked condition, pull the belts once forcefully and then return them. After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a “click” is heard.

Warning
► Never wear the lap portion of the belt across your abdomen. During accidents
it can press sharply against the abdomen and increase the risk of injury.
► The seat belts must not be twisted when worn.
3. Pull the belt slightly to adjust slackness as desired.
See also:
For the front seat
The cup holder is located in front of the floor console.
Type 1
Type 2
To use the cup holder, open the lid.
...
If the DPF warning display illuminates during vehicle operation
Steady illumination of the DPF warning display shows that the DPF has not been
able to burn away all of the trapped PM and that, as a result, an excessive amount
of PM has accumulated inside it. T ...
Electrical system
Vehicles equipped with Auto Stop & Go (AS&G) system
Note
► For vehicles equipped with the Auto Stop & Go (AS&G) system, contact a MITSUBISHI
MOTORS Authorized Service Poin ...
