Auto reset mode
► When the average speed is being displayed, if you hold down the multi-information meter switch, the average speed displayed at that time is reset.
► If the ignition switch is at “ACC” or “LOCK” for about 4 hours or longer, the average speed display is automatically reset.
Note
► The average speed display and the average fuel consumption display can be reset
individually for the auto reset mode and manual reset mode.
► “---” is displayed when the average speed cannot be measured.
► The initial (default) setting is “Auto reset mode”.
► The display setting can be changed to the preferred units (km/h or mph).
Refer to “Changing the function settings (when the ignition switch is “ON”)”.
► The memory of the auto reset mode or manual reset mode for the average speed display
is erased if the battery is disconnected.
See also:
Heater/Manual air conditioning*
The heater and the air conditioning can be operated while the engine is running.
The performance of the heater is directly related to the temperature of the engine
coolant, so operate the heater ...
Passenger compartment (LHD vehicles)
The fuse blocks in the passenger compartment are located behind the fuse lid
in front of the driver’s seat at the position shown in the illustration.
A- Main fuse block
B- Sub fuse block
1. O ...
Emergency stop signal system
This is a device that reduces the possibility of rear end collisions by the rapid
and automatic blinking of the hazard warning lamps to alert vehicles approaching
from behind during sudden braking ...