Manual reset modeManual reset mode  - Average fuel consumption display - Multi-information display - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset.

    See also:

    Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
    1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle. : Front of the vehicle 2 ...

    SRS warning
    This warning lamp/display is shared by the SRS airbags and the pretensioner seat belts. Refer to “SRS warning lamp/display”. ...

    Safety and disposal information for used engine oil
    WARNING • Prolonged and repeated contact may cause serious skin disorders, including dermatitis and cancer. • Avoid contact with the skin as far as possible and wash thoroughly after any co ...