Headlamp flasherHeadlamp flasher  - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The high-beams flash when the lever is pulled slightly (2), and will go off when it is released.

When the high-beam is on, the high-beam indication lamp in the instrument cluster will illuminate.

► The high-beams can also flash when the lamp switch is OFF. Note

► The high-beams can also flash when the lamp switch is OFF.
► If you turn the lamps off with the headlamps set to high-beam, the headlamps are automatically returned to their low-beam setting when the lamp switch is next turned to theWelcome light (for vehicles equipped with the keyless entry system or the keyless position.

    See also:

    Steering wheel lock
    To lock Turn the steering wheel until it is locked. To unlock Turn the ignition switch to the “ACC” position while moving the steering wheel slightly right and left. Caution ► Carr ...

    To change a tyre
    1. If a wheel cover is installed, first remove the cover. (Refer to “Wheel covers”.) Then loosen the wheel nuts a quarter turn with the wheel nut wrench. Do not remove the wheel nuts yet. 2 ...

    Indication lamp
    1. When the ignition switch is turned “ON”, the TCL indication lamp illuminates and goes out after a few seconds. 2. When SLIP control is exerted while driving, the TCL indication lamp will il ...