Rear room lampRear room lamp  - Interior lamps - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The room lamp can be turned on by sliding the room lamp switch.

1 (ON) - The room lamp goes on.

1 (ON) - The room lamp goes on.

2 ( ) - The lamp illuminates when a door or the rear hatch is opened. It goes off about 15 seconds after the door or rear hatch is closed.

However, the lamp goes off immediately in the following cases: ► The ignition switch is turned to the “ON” position.

► All the doors and the rear hatch are locked using the central door lock function.

► If the vehicle is equipped with the keyless entry system, when the remote control switch of the keyless entry system is used to lock the vehicle.

► If the vehicle is equipped with the keyless operation system, when the remote control switch of the keyless operation system or the keyless operation function is used to lock the vehicle.

► When the key was used to start the engine, if the key is removed while the Note

► When the key was used to start the engine, if the key is removed while the doors and rear hatch are closed, the lamp is illuminated and after about 15 seconds it goes off.

► When the keyless operation function was used to start the engine, if the ignition switch is turned to the “LOCK” position while the doors and rear hatch are closed, the lamp illuminates and after about 15 seconds it goes off.

► The time until the lamp goes off can be adjusted.

For details, please consult a MITSUBISHI MOTORS Authorized Service Point.

If the vehicle is equipped with the MITSUBISHI Multi-Communication System (MMCS), adjustment can be made using screen operations. Refer to the separate owner’s manual for details.

3 (OFF) - The lamp goes off.

    See also:

    Active Stability Control (ASC) OFF display screen*
    This is displayed when the Active Stability Control (ASC) is turned off with the ASC OFF switch. If there is a fault with the ASC, the ASC OFF display is shown. Refer to ““ASC OFF” switch ...

    Keyless operation key take-out monitoring system
    Type 1 Type 2 When the vehicle is parked with the ignition switch in any position other than “LOCK” (PUSH OFF), if you close the door after opening any of the doors and taking the keyles ...

    Parking
    To park the vehicle, fully engage the parking brake, and then move the gearshift lever to 1st or “R” (Reverse) position for vehicles equipped with M/T, or set the selector lever (CVT) or gears ...