Antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained
NOTE
• Be sure to remove the roof antenna in the following cases:
• When using an automatic car wash.
• When placing a car cover over the vehicle.
• When driving into a structure that has a low ceiling.
See also:
To listen to the radio
1- PWR (On-off) switch 2- VOL (Volume control) knob 3- U/M/L (UKW/MW/LW selection)
button 4- Audio adjust button 5- AUDIO button 6- TUNE/SEEK (Down-step/Down-seek)
button 7- TUNE/SEEK (Up-step/U ...
Headlamp levelling switch (except for vehicles with discharge headlamps)
The angle of the headlamp beam varies depending on the load carried by the vehicle.
The headlamp levelling switch can be used to adjust the headlamp illumination
distance (when the lower beam is il ...
Coming home light
This function turns on the headlamps in the low beam setting for about 30 seconds
after the ignition switch is turned to the “OFF” position or the operation mode
is put in OFF.
1. Turn the co ...