Headlamp washer switch*
The headlamp washer can be operated with the ignition switch “ON” position and
the lamp switch at “
” or “
”
position.
1- Push the button once and the washer fluid will be sprayed on to the headlamps.
NOTE
Check the headlamp washers periodically to confirm that the washer fluid is being sprayed properly on to the headlamp lenses.
See also:
Changing the language cooperative control
The language used in MITSUBISHI Multi-Communication System (MMCS) (if so equipped)
or the Bluetooth® 2.0 interface (if so equipped) can be changed automatically to
the same language as that shown ...
To remove
1. Wrap the tip of the bar with a cloth, insert it deeply into the notch provided
in the wheel cover, and use it to lever up the cover a little.
2. With the cover raised a little, pry it off comp ...
Changing the reset mode for average fuel consumption and average speed
The mode conditions for the average fuel consumption and average speed display
can be switched between “Auto reset” and “Manual reset”.
1. Press and hold the multi-information meter switch ...