Operation of the outside rear-view mirrors (Vehicles equipped with mirror retractor switch)Operation of the outside rear-view mirrors (Vehicles equipped with mirror 
retractor switch)  - Keyless entry system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

To fold

Within 30 seconds of locking the doors and tailgate using the LOCK switch (1), press the LOCK switch twice rapidly to fold the outside rear-view mirrors.

To extend

Within 30 seconds of unlocking the doors and tailgate using the UNLOCK switch (2), press the UNLOCK switch twice rapidly to return the outside rear-view mirrors to their extended positions.

The outside rear-view mirrors are not initially set to work as described above. If you want them to work as described above, you need to set them so that they do not retract/extend when the doors and tailgate are locked/unlocked using the keyless entry system or keyless operation system.

Refer to “Starting and driving: Outside rear-view mirrors”.

For details, please consult a MITSUBISHI MOTORS Authorized Service Point.

In a vehicle equipped with the MITSUBISHI Multi- Communication System (MMCS), it is possible to change the setting by means of screen operations.

Refer to the separate owner’s manual for details.

• The keyless entry system does not operate in the following conditions: NOTE

• The keyless entry system does not operate in the following conditions:
• The key is left in the ignition switch.
• The door or tailgate is open.
• The remote control switch will operate within approximately 4 m from the vehicle. However, the operating range of the remote control switch may change if the vehicle is located near a power station, or radio/TV broadcasting station.
• If either of the following problems occurs, the battery may be exhausted.
• The remote control switch is operated at the correct distance from the vehicle, but the doors and tailgate are not locked/unlocked in response.
• The indication lamp (3) is dim or does not come on.

For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.

If you replace the battery yourself, refer to “Procedure for replacing the remote control switch battery”.

• If your remote control switch is lost or damaged, please contact your MITSUBISHI MOTORS Authorized Service Point for a replacement remote control switch.
• If you wish to add a remote control switch, we recommend you to contact a MITSUBISHI MOTORS Authorized Service Point.

A maximum of 8 remote control switches are available for your vehicle.

    See also:

    To turn from “ACC” to “LOCK”
    1. [Vehicles equipped with M/T] Push the emergency key in at the “ACC” position and keep it depressed until it is turned to the “LOCK” position, and remove it. [Vehicles equipped with CVT ...

    If the warning lamp/display illuminate while driving
    If only the ABS warning lamp/display illuminate Avoid hard braking and high-speed driving. Stop the vehicle in a safe place. Restart the engine and check to see whether the lamp goes out after a few ...

    Average fuel consumption display
    This displays the average fuel consumption from the last reset to the present time. There are the following 2 mode settings. For information on how to change the average fuel consumption display s ...