Active Stability Control (ASC) OFF display screen*
OFF display screen* - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>
This is displayed when the Active Stability Control (ASC) is turned off with the ASC OFF switch.
If there is a fault with the ASC, the ASC OFF display is shown.
Refer to ““ASC OFF” switch”.
See also:
Tips for starting
(1) Do not operate the starter motor continuously for anything longer than 10
seconds; doing so could run down the battery. If the engine does not start, turn
the ignition switch back to “LOCK ...
To lock
Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal
lamps will blink once.
Note
► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1 ...
Other interrupt displays (when the ignition switch is “ON”)
The operation status of each system is displayed on the information screen. Refer
to the appropriate page for the system for further details.
This informs you that a periodic inspection is due.
...