Interrupt display screen (when the ignition switch or the operation mode is ON)Interrupt display screen (when the ignition switch or the operation mode is<span lang= ON) - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>

Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Instruments and controls / Multi-information display / Interrupt display screen (when the ignition switch or the operation mode is ON)

Warning display

When there is information to be announced, such as a system fault, a sound is emitted and the information screen switches to the warning display screen.

Refer to the warning list and take the necessary measures.

Refer to “Warning display list (when the ignition switch or the operation mode is ON)”.

When the cause of the warning display is eliminated, the warning display goes out automatically.

Instruments and controls

To return to the screen displayed before the warning display

Even if the cause of the warning display is not eliminated, you can return to the screen that was displayed before the warning display.

If you press the multi-information meter switch, the display screen switches to the screen that was displayed before the warning display and the mark (A) is displayed.

NOTE

• Warning display screens with mark NOTE

• Warning display screens with displayed in the upper right of the screen can be switched. If you want to switch mark displayed in the upper right of the screen can be switched. If you want to switch the display, press the multi-information meter switch as follows.

: Press lightly.

Redisplay of a warning display screen: Press for about 2 seconds or more.

Redisplay of a warning display screen

When the if you lightly press the multi-information meter switch a few times, the warning mark is displayed, if you lightly press the multi-information meter switch a few times, the warning display screen you switched from is displayed again.

Other interrupt displays

The operation status of each system is displayed on the information screen.

Refer to the appropriate page in the warning display list for further details.

Refer to “Other interrupt displays”.

    See also:

    Height adjustment
    Adjust the head restraint height so that the centre of the restraint is as close as possible to eye level to reduce the chances of injury in the event of collision. Any person too tall for the r ...

    Parking
    To park the vehicle, fully engage the parking brake, and then move the gearshift lever to 1st or “R” (Reverse) position for vehicles equipped with M/T, or set the selector lever to “P” (PA ...

    Odometer/Tripmeter
    When the ignition switch is turned “ON”, the odometer display is given in the lower display window (1). The upper display window (2) shows the tripmeter A and tripmeter B distances in that s ...