Selector lever position display screen*

Shows the position of the selector lever.
Refer to “Selector lever operation”.
See also:
Welcome light
This function turns on the position and tail lamps for about 30 seconds after
the UNLOCK switch (A) on the remote control transmitter is pressed when the combination
headlamps and dipper switch is ...
Setting the system
Follow the procedure below to set the system to the system armed mode.
1. Turn the ignition switch to the “LOCK” position.
If you started the engine with the key, remove the key from the ignitio ...
Position lamps (except for vehicles equipped with high intensity discharge headlamps)
1. For petrol-powered vehicles equipped with turbocharger, when replacing the
bulb on the left side, remove the bolt (A) holding down the relay box and move the
relay box towards the rear of the v ...
