Dipper (High/Low beam change)Dipper (High/Low beam change) - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

When the lamp switch is in the the beam changes from high to low (or low to high) each time the lever is pulled position, the beam changes from high to low (or low to high) each time the lever is pulled fully (1). While the high beam is on, the high-beam indication lamp in the instrument cluster will also illuminate.

Headlamp flasher

    See also:

    To install
    1. Make sure the tabs (A) of the back of the wheel cover are not broken and correctly fitted on the rings (B). If in doubt, do not install the wheel cover and consult your MITSUBISHI MOTORS Author ...

    Twin Clutch SST control mode
    Select the control mode from the following two types to suit the driving conditions. Note ► When continuously driving on closed circuit tracks or at other locations where the engine is op ...

    Front turn-signal lamps
    1. Remove the clips (A) and clips (B), then remove the duct (C) and the upper cover (D). 2. Remove the entire socket and bulb assembly (E) by turning it anticlockwise. : Front of the vehicle ...