Diesel preheat indication lamp (diesel-powered vehicles)
This indication lamp illuminates when the ignition switch is placed in the “ON” position. As the glow plug becomes hot, the lamp goes out and the engine can be started.
Note
► If the engine is cold, the diesel preheat indication lamp is on for a longer
time.
► When the engine has not been started within about 5 seconds after the diesel preheat
indication lamp went out, return the ignition switch to the “LOCK” position.
Then, turn the switch to the “ON” position to preheat the engine again.
► When the engine is warm, the diesel preheat indication lamp does not come on even
if the ignition switch is placed in the “ON” position.
See also:
Cancelling the system
When the following operation is performed, the doors and rear hatch will unlock
and the Dead Lock System will be simultaneously cancelled.
► The UNLOCK switch (D) on the remote control switch ...
Operating the system in manual air mode
Blower speed and ventilator mode may be controlled manually by setting the blower
speed selection dial and the mode selection dial to the desired positions.
To return to automatic operation, set th ...
Disposal information for used batteries
Your vehicle contains batteries and/or accumulators.
Do not mix with general household waste.
For proper treatment, recovery and recycling of used batteries, please take them
to applicable colle ...