ABS warning lamp/display
Warning lamp
If there is a malfunction in the system, the ABS warning lamp will come on and the warning display will appear on the information screen in the multi-information display.
Under normal conditions, the ABS warning lamp only comes on when the ignition switch is turned to the “ON” position and goes off a few seconds later.
Caution
► Any of the following indicates that the ABS is not functioning and only
the standard brake system is working. (The standard brake system is functioning
normally.) If this happens, we recommend you to have your vehicle inspected as soon
as possible.
• When the ignition switch is in the “ON” position, the warning lamp does not come
on or it remains on and does not go off
• The warning lamp comes on while driving
• The warning display appears while driving
See also:
Rear fog lamp
1. Remove the socket and bulb assembly by turning it anticlockwise.
2. Remove the bulb by pulling it out.
3. To install the bulb, perform the removal steps in reverse. ...
If the vehicle breaks down
If the vehicle breaks down on the road, move it to the shoulder and use the hazard
warning flashers.
If the engine stops/fails
Vehicle operation and control are affected if the engine stops. Befor ...
When turning from “LOCK” to “ACC”
1. Take the emergency key out of the keyless operation key. Refer to “Emergency
key”.
2. Remove the ignition switch cover while pressing the lock release button (A).
3. Insert the emergency ...