LW/MW/FM digital tuning radio with CD changerLW/MW/FM digital tuning radio with CD changer  - For pleasant driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The audio system can only be used when the ignition switch is in the “ON” or “ACC” position.

► When listening to the audio system while the engine is not running, be sure Note

► When listening to the audio system while the engine is not running, be sure to turn the ignition switch to the “ACC” position.
If the ignition switch is left in the “ACC” position, the accessory power will automatically turn off after a certain period of time and you will no longer be able to use the audio system. The accessory power comes on again if the ignition switch is turned from the “ACC” position. Refer to “ACC power autocutout function”.
► If a cellular phone is used inside the vehicle, it may create noise from the audio equipment.
This does not mean that anything is wrong with your audio equipment. In such a case, use the cellular phone at a place as far away as possible from the audio equipment.
► If foreign objects or water get into the audio equipment, or if smoke or a strange odour comes from it, immediately turn off the audio system. We recommend you to have it checked. Never try to repair it by yourself.
Avoid continuous usage without inspection by a qualified person.
► The audio amplifier (if so equipped) is located under the front left seat. Do not subject the amplifier to a strong impact. It could damage the amplifier or malfunctioning could result.

See also:

How the Supplemental Restraint System works
The SRS includes the following components: 1- Airbag module (Driver) 2- Front passenger’s airbag OFF indication lamp 3- Airbag module (Passenger) 4- Driver’s knee airbag module* 5- Front pa ...

To lock
Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once. Note ► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1 ...

Cargo room lamp
When replacing the bulb, put the cargo room lamp switch into the “OFF” position. 1. Insert a straight blade (or minus) screwdriver with a cloth over its tip into the notch of the lamp assembly ...