AWC control fluidAWC control fluid - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

To check the fluid level

The AWC control fluid reservoir is in the luggage compartment.

► Check the fluid level in the reservoir 90 minutes or more after turning the Note

► Check the fluid level in the reservoir 90 minutes or more after turning the ignition switch to the “LOCK” position.

1. Remove the lid of the cargo floor box (A) on the right side.

2. Remove the cover (B) while pressing the top of the cover (B) and the hook

2. Remove the cover (B) while pressing the top of the cover (B) and the hook (C).

3. Check to make certain that the AWC control fluid level is always between the

3. Check to make certain that the AWC control fluid level is always between the “MAX” and “MIN” level markings on the fluid reservoir and top up the fluid, if necessary.

Note

► Do not spill the fluid onto the luggage compartment. Note

► Do not spill the fluid onto the luggage compartment.

If fluid is spilled, wipe it up immediately.

4. To install the cover, perform the removal steps in reverse.

Fluid type

Washer fluid

    See also:

    Full-time 4WD
    Full-time 4WD vehicles are propelled by engine power distributed constantly and appropriately to all 4 wheels. Not only does this ensure better handling on dry, paved roads but also permits bette ...

    The side airbags and curtain airbags ARE NOT DESIGNED TO DEPLOY when…
    The side airbags and curtain airbags are not designed to deploy in conditions where they cannot usually provide protection to the occupant. Typical conditions are shown in the illustration. 1- ...

    If your vehicle tows another vehicle
    1. Take out the towing hook, wheel nut wrench and jack bar. Refer to “Tools and jack”. 2. Cover the tip of the jack bar with a cloth, then use it to remove the cover (D) that is located on th ...