Doors
CAUTION
• Make sure the doors are closed: driving with doors not completely closed
is dangerous.
• Never leave children in the vehicle unattended.
• Be careful not to lock the doors while the key is inside the vehicle.
NOTE
• To prevent the key from being locked inside the vehicle, neither the lock knob on the driver’s door nor the key can be used to lock the driver’s door when it is open.
To lock or unlock with the key
1- Lock
2- Unlock
NOTE
• When locking or unlocking with the key, only the driver’s door will be locked or unlocked.
To lock or unlock all doors and the tailgate, use the central door lock switch, the keyless entry system or the keyless operation function.
Refer to “Central door locks” on pages 1-22, “Keyless entry system” on pages 1-04, 1-18, and “To operate using the keyless operation function”.
• If the vehicle is equipped with the keyless operation system, the driver’s door can be locked or unlocked with the emergency key.
Refer to “Emergency key”.
To lock or unlock from inside the vehicle
1- Lock
2- Unlock
Pull the inside door handle towards you to open the door.
NOTE
• The driver’s door can be opened without using the lock knob by pulling on the
inside door handle.
• In a vehicle that has a Dead Lock System, it is not possible to unlock the
door by pushing the lock knob to the unlock side while the Dead Lock System is set.
(Refer to “Dead Lock System”.)
To lock without using the key
Front passenger’s door, Rear door
Set the inside lock knob (1) to the locked position, and close the door (2).
NOTE
• The driver’s door cannot be locked using the inside lock knob while the driver’s door is opened.
Operation mode ON reminder system
For vehicles equipped with the keyless operation system
If the driver’s door is opened with the engine stopped and the operation mode in any position other than OFF, the operation mode ON reminder buzzer sounds intermittently to remind you to put the operation mode in OFF.
In addition, the warning display will be displayed on the information screen in the multi-information display.
See also:
Bending lamps (Adaptive Front lighting System (AFS)) (for vehicles equipped
with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2 ...
Function setting screen
The “Display language”, “Temperature unit”, “Fuel consumption unit”, and “Average
fuel consumption and speed reset method” etc. settings can be modified as desired.
Refer to “Ch ...
3-point type seat belt (with emergency locking mechanism)
This type of belt requires no length adjustment.
Once worn, the belt adjusts itself to the movement of the wearer, but in the
event of a sudden or strong shock, the belt automatically locks to hold ...