Odometer/TripmeterOdometer/Tripmeter - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

Each time you lightly press the multi-information meter switch, the display screen switches.

Odometer/Tripmeter → Service reminder → Redisplay of a→ Odometer/Tripmeter warning display screen → Odometer/Tripmeter → Service reminder → Redisplay of a warning display screen → Odometer/Tripmeter Odometer

Odometer

The odometer indicates the distance travelled.

Tripmeter

The tripmeter indicates the distance travelled between two points.

Example usage of tripmeter It is possible to measure two currently and tripmeter travelled distances, from home using tripmeter It is possible to measure two currently travelled distances, from home using tripmeter way using tripmeter . and from a particular point on the way using tripmeter To reset the tripmeter.

To reset the tripmeter

To return the display to 0, hold down the multi-information meter switch for about 2 seconds or more. Only the currently displayed value will be reset.

Example

If tripmeter tripmeter will be reset. is displayed, only tripmeter will be reset.

NOTE

• If there is no warning display, the switching sequence is: Odometer/Tripmeter NOTE

• If there is no warning display, the switching sequence is: Odometer/Tripmeter → Service reminder → Odometer/Tripmeter → Odometer/ Tripmeter .→ Service reminder → Odometer/Tripmeter • Both tripmeters and.

• Both tripmeters can count up to 9999.9 km (9999.9 miles). and When a tripmeter goes past 9999.9 km (9999.9 miles), it returns to 0.0 km (0.0 can count up to 9999.9 km (9999.9 miles).

When a tripmeter goes past 9999.9 km (9999.9 miles), it returns to 0.0 km (0.0 miles).

• When disconnecting the battery terminal, the memories of tripmeter display are erased, and their displays return and display to 0.0 km (0.0 miles). are erased, and their displays return to 0.0 km (0.0 miles).

Service reminder

Service reminder

This displays the distance and number of months until the next periodic inspection.

Refer to “Service reminder”.

    See also:

    Disconnection and connection
    To disconnect the battery cable, stop the engine, first disconnect the negative (–) terminal and then the positive (+) terminal. When connecting the battery, first connect the positive (+) termi ...

    Link System
    The Link System takes overall control of the devices connected via the USB input terminal or the Bluetooth® 2.0 interface allowing the connected devices to be operated by using the switches in th ...

    Changing the security alarm settings
    It is possible to set the security alarm to the “active” mode or “inactive” mode. Follow the procedure below. 1. Except for vehicles equipped with the keyless operation system, remove the ...