Average fuel consumption display
This displays the average fuel consumption from the last reset to the present time.
There are the following 2 mode settings.
For information on how to change the average fuel consumption display setting, refer to “Changing the function settings (when the ignition switch or the operation mode is ON)”.
The mark (A) in the momentary fuel
gauge shows the average fuel consumption. (Type 2)
Manual reset mode
• When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset.
• When the following operation is performed, the mode setting is automatically switched from manual to auto.
[Except for vehicles equipped with keyless operation system]
Turn the ignition switch from the “ACC” or “LOCK” position to the “ON” position.
[For vehicles equipped with keyless operation system]
Change the operation mode from ACC or OFF to ON.
Switching to auto occurs automatically. If switching to manual mode is done, however, the data from the last reset is displayed.
Auto reset mode
• When the average fuel consumption is being displayed, if you hold down the multi-information meter switch, the average fuel consumption displayed at that time is reset.
• When the engine switch or the operation mode is in the following conditions, the average fuel consumption display is automatically reset.
[Except for vehicles equipped with keyless operation system]
The ignition switch is in the “ACC” or “LOCK” position for about 4 hours or longer.
[For vehicles equipped with keyless operation system]
The operation mode is in ACC or OFF for about 4 hours or longer.
NOTE
• The average speed display and the average fuel consumption display can be reset individually for the auto reset mode and manual reset mode.
• “---” is displayed when the average fuel consumption cannot be measured.
• The initial (default) setting is “Auto reset mode”.
• The average fuel consumption depends on the driving condition (road condition, driving behavior, etc.). The displayed fuel consumption may vary from the actual fuel consumption.
Treat the fuel consumption displayed as just a rough guideline.
• The memory of the auto reset mode or manual reset mode for the average fuel consumption display is erased if the battery is disconnected.
• The display setting can be changed to the preferred units {km/L, mpg (US), mpg (UK) or L/100 km}. Refer to “Changing the function settings (when the ignition switch or the operation mode is ON)”.
See also:
Setting of door and tailgate unlock function (Except for vehicles equipped
with
a Dead Lock System)
The door and tailgate unlock function can be set to the following two conditions.
Each time the door and tailgate unlock function is set, a chime will sound to
tell you the condition of the door an ...
Jacking up the vehicle
1. Park the vehicle on a level and stable ground. 2. Activate the hazard flashers
and turn the ignition key to the “LOCK” position. 3. Set the parking brake firmly,
move the gearshift lever (m ...
Control panel
A- Temperature control dial
B- Air selection switch
C- Blower speed selection dial
D- Air conditioning switch
E- Mode selection dial
F- Rear window demister switch
NOTE
• On vehicles with ...