Parking brake break-in
Break-in the parking brake linings whenever the brake performance of the parking brake is insufficient or whenever the parking brake linings and/or discs are replaced, in order to assure the best brake performance.
This procedure is described in the vehicle service manual and can be carried out by a MITSUBISHI MOTORS Authorized Service Point.
See also:
Brake fluid
Check the brake fluid level in the reservoir. The brake fluid level must be between
the “MAX” and “MIN” marks on the reservoir. The fluid level falls slightly with
wear of the brake pads ...
Fuel injection amount learning process (diesel-powered vehicles)
To keep exhaust emissions and engine noise low, the engine very occasionally
performs a learning process for the fuel injection amount.
The engine sounds slightly different from usual while the lea ...
Starting and stopping the
Tips for starting
• The operation mode can be in any mode to start the engine.
• The starter motor will be turning for up to approximately 15 seconds if the
engine switch is released at once ...