Indication lamp
1. When the ignition switch is turned “ON”, the TCL indication lamp illuminates
and goes out after a few seconds.
2. When SLIP control is exerted while driving,
the TCL indication lamp will illuminate.
CAUTION
(1) If the TCL indication lamp stays on or does not illuminate when the
ignition switch is turned ”ON”, it indicates that any malfunction may occur in the
system.
(2) If the TCL indication lamp flashes when you drive the vehicle, it
indicates that any malfunction occurs in the system. When either (1) or (2) happens,
have your vehicle checked at an authorized MITSUBISHI dealer.
See also:
If the warning display appears while driving
1. Stop the vehicle in a safe place and turn off the engine.
2. Wait approximately 30 seconds and then restart the engine to check whether the
warning display goes out; if it then remains off, ther ...
Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt
(A) holding down the washer tank spout and move the spout towards the rear of the
vehicle.
: Front of the vehicle
2 ...
Uphill/downhill driving
DRIVING UPHILL
The Twin Clutch SST may not upshift to a higher shift position if the computer
determines the current speed cannot be maintained once a higher shift position is
engaged.
For smoot ...
