TP (Traffic information Program) search function
The traffic information program standby function is turned on (with the TP indicator (11) shown on the display) and after about 45 seconds since the RDS indicator (9) turns off due to weak signal or the tuning station is changed over form a TP station to a station which does not broadcast traffic information, the sound will beep 5 times and seeks out a TP station in all frequencies automatically.
To turn the function off, switch off the power from UKW mode, and while pressing TP button (2), press the PWR switch (1) until it beeps. The ”TP–S OFF” will be shown on the display.
To turn the function on, use the same procedure.
See also:
Trailer towing
In order to tow a trailer with your vehicle, have a trailer towing device that
meets all relevant regulations in your area, mounted consult a MITSUBISHI MOTORS
Authorized Service Point.
The regul ...
Emergency starting
If the engine cannot be started because the battery is weak or dead, the battery
from another vehicle can be used with jumper cables to start the engine.
Warning
► To start the engine using ...
Selector lever operation
Except for vehicles with Sports mode
The transmission has 4 forward gears and 1 reverse gear.
The individual gears are selected automatically, depending on the position of
the gear selector leve ...
