Headlamps and position lamps

Remove the sealing cover by turning it anticlockwise and disconnect the connector.
See also:
Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing
sensor system operation indication lamp will blink and the warning buzzer will sound
for approximately 5 seconds. Even ...
Fuse replacement
1. Before replacing a fuse, always turn off the electrical circuit concerned
and place the ignition switch in the “LOCK” position.
2. Remove the fuse puller (A) from the inside of the fuse box ...
ACD control mode switch
When the ignition switch is set to the “ON” position, operate the AWC switch
to change the control mode.
Each time the switch is pushed, the control mode changes in the order “TARMAC”
...
