Spot lamps

Insert a straight blade (or minus) screwdriver into the notch of the lamp assembly and pry gently to remove the lens.
Remove the bulb from the lamp holder.
NOTE
Wrap a piece of cloth around the straight blade (or minus) screwdriver in order to avoid scratching the lens.

See also:
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position,
and goes off after a few seconds.
Always make sure that the lamp goes off before driving.
With the ignition swi ...
Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly.
If the lamps do not illuminate, the probable cause is a blown fuse or defective
lamp bulb. Check the fuses fir ...
Twin Clutch SST control mode
When the ignition switch is set to the “ON” position, operate the Twin Clutch
SST control mode switch (A) to change the control mode.
When the engine is started, the control mode is automatic ...
