Rear seatRear seat - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Armrest

To use the armrest, fold it down.

To return to the original position, push it backward level with the seat.

Note

► The top surface of the armrest contains a cup holder for rear seat occupants. Note

► The top surface of the armrest contains a cup holder for rear seat occupants.

Refer to “Cup holder”.

    See also:

    Procedure for replacing the remote control switch battery
    1. Remove the screw (A) from the remote control switch. 2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight blade (or minus) screwdriver into the notch in the remot ...

    Operation of the Dead Lock System
    In a vehicle that has a Dead Lock System, it is possible to set the Dead Lock System using the remote controller. (Refer to “Dead Lock System”.) ...

    Warning lamps
    Brake warning lamp This lamp illuminates when the ignition switch is turned to the “ON” position or the operation mode is put in ON, and goes off after a few seconds. Always make sure that t ...