Front passenger’s airbag OFF indication lampFront passenger’s airbag OFF indication lamp  - Front passenger’s airbag ON-OFF switch - Supplemental restraint system (SRS) - airbag - Seat and seat belts - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The front passenger’s airbag OFF indication lamp is located in the instrument panel.

The indication lamp normally comes on when the ignition switch is turned to the

The indication lamp normally comes on when the ignition switch is turned to the “ON” position, and goes off a few seconds later.

When the front passenger’s airbag ON-OFF switch is turned OFF, the indication lamp will stay on to show that the front passenger’s airbag is not operational.

When the front passenger’s airbag ON-OFF switch is turned ON, the indication lamp goes off to show that the front passenger’s airbag is operational.

► Do not fit any accessory that makes the indication lamp impossible to see, Warning

► Do not fit any accessory that makes the indication lamp impossible to see, and do not cover the indication lamp with a sticker.
You would not be able to verify the status of the passenger airbag system.
► To reduce risk of serious or fatal injury:
• Always remove the key from the ignition switch before operating a front passenger’s airbag ON-OFF switch.
Failure to do so could adversely affect the airbag performance.
• Wait at least 60 seconds to operate the front passenger’s airbag ON-OFF switch after turning the ignition switch from “ON” position to “LOCK” position.
The SRS airbag system is designed to retain enough voltage to deploy the airbag.
• Always remove the key from the front passenger’s airbag ON-OFF switch after operating that switch. Failure to do so could lead to improper position of the front passenger’s airbag ONOFF switch.
• Do not turn OFF the front passenger’s airbag ON-OFF switch except when a rearward facing child restraint system is fitted to the front passenger seat.
• If the indication lamp does not come on when the front passenger’s airbag ON-OFF switch is turned OFF, do not fit a rearward facing child restraint system to the front passenger seat. We recommend you to have the system inspected by a MITSUBISHI MOTORS Authorized Service Point.
• If the indication lamp remains on when the front passenger’s airbag ONOFF switch is turned ON, do not allow anyone to sit on the front passenger seat. We recommend you to have the system inspected by a MITSUBISHI MOTORS Authorized Service Point.

To turn an airbag off, follow these steps: 1. Insert the key into front passenger’s airbag ON-OFF switch, and turn it to the “OFF” position.
2. Remove the key from the key opening of that front passenger’s airbag ON-OFF switch.
3. Insert the key into the ignition switch, and turn the ignition to the “ON” position. The front passenger’s airbag OFF indication lamp will stay on.

The front passenger’s airbag is now deactivated and will not deploy until switched

The front passenger’s airbag is now deactivated and will not deploy until switched on again.

    See also:

    Interior lamps
    1- Luggage room lamp 2- Room lamp (rear)* 3- Map & room lamps (front) Sunshade illumination dimming control switch* NOTE • If you leave the lamps on without running the engine, you will r ...

    Voice recognition function
    The Bluetooth® 2.0 interface is equipped with a voice recognition function. Simply say voice commands and you can perform various operations and make or receive hands-free calls. With the Bluetoo ...

    Instruments and controls
    LHD 1. Combination headlamps and dipper switch Turn-signal lever Front fog lamp switch* Rear fog lamp switch Headlamp washer switch* 2. Instruments 3. Shift paddles* 4. Windscreen ...