Tyre inflation pressuresTyre inflation pressures  - Tyres - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1600 models

Check the tyre inflation pressure of all the tyres while they are cold; if insufficient

Check the tyre inflation pressure of all the tyres while they are cold; if insufficient or excessive, adjust to the specified value.

After the tyre inflation pressure has been adjusted, check the tyres for damage and air leaks. Be sure to put caps on the valves.

1800 models (petrol-powered vehicles)

1: Vehicles for Russia, Kazakhstan and Ukraine

1: Vehicles for Russia, Kazakhstan and Ukraine
2: Above 160 km/h (99 mph)
3: Except for vehicles for Russia, Kazakhstan and Ukraine

Check the tyre inflation pressure of all the tyres while they are cold; if insufficient or excessive, adjust to the specified value.

After the tyre inflation pressure has been adjusted, check the tyres for damage and air leaks. Be sure to put caps on the valves.

1800 models (diesel-powered vehicles)

: Above 160 km/h (99 mph)

: Above 160 km/h (99 mph)

Check the tyre inflation pressure of all the tyres while they are cold; if insufficient or excessive, adjust to the specified value.

After the tyre inflation pressure has been adjusted, check the tyres for damage and air leaks. Be sure to put caps on the valves.

2000 models

Above 160 km/h (99 mph)

Above 160 km/h (99 mph)

Check the tyre inflation pressure of all the tyres while they are cold; if insufficient or excessive, adjust to the specified value.

After the tyre inflation pressure has been adjusted, check the tyres for damage and air leaks. Be sure to put caps on the valves.

    See also:

    Bottle holder
    CAUTION • Do not drink beverages while driving. This is distracting and could cause an accident. • Drinks could be spilled by the vibration and jolts while driving. If the spilt drink is ver ...

    To lock
    Press the LOCK switch (1). All the doors and rear hatch will be locked. The turn-signal lamps will blink once. Note ► With a vehicle that has a Dead Lock System, pressing the LOCK switch (1 ...

    ACD control mode switch
    When the ignition switch is set to the “ON” position, operate the AWC switch to change the control mode. Each time the switch is pushed, the control mode changes in the order “TARMAC”  ...