Adjustable seat belt anchor (front seats)
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob (A) depressed. To move the anchor up, slide it without depressing the lock knob (A).
Warning
► When adjusting the seat belt anchor, set it at a position that is sufficiently high so that the belt will make full contact with your shoulder but will not touch your neck.
See also:
Antenna
To remove
Turn the pole (A) anticlockwise.
To install
Screw the pole (A) clockwise into the base (B) until it is securely retained
NOTE
• Be sure to remove the roof antenna in the following ...
To check the coolant level
A transparent coolant reserve tank (A) is located in the engine compartment.
The coolant level in this tank should be kept between the “LOW” and “FULL” marks
when measured while the engine ...
Parking
To park the vehicle, fully engage the parking brake, and then move the gearshift
lever to 1st or “R” (Reverse) position for vehicles equipped with M/T, or set the
selector lever to “P” (PA ...