To unlockTo unlock  - Keyless entry system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

Press the UNLOCK switch (2). All the doors and the tailgate will be unlocked. If the doors and tailgate are unlocked when the front room lamp switch is in the “DOOR” position or the rear room lamp switch (except for vehicles equipped with the sunshade) is in the middle (•) position, the room lamp will illuminate for approximately 15 seconds and the turn-signal lamps will blink twice.

Depending on the vehicle model, the position and tail lamps can also be set to turn on for approximately 30 seconds. Refer to “Instruments and controls:

Welcome light”.

• Except for vehicles equipped with a Dead Lock System, the door and tailgate NOTE

• Except for vehicles equipped with a Dead Lock System, the door and tailgate unlock function can be set so that only the driver’s door unlocks when the UNLOCK switch (2) is pressed once.

If the door and tailgate unlock function is set to work as described above, all the doors and the tailgate unlock when the UNLOCK switch is pressed two times in succession.

Refer to “Setting of door and tailgate unlock function”.

• The indication lamp (3) comes on each time a switch is pressed.

• For vehicles equipped with the mirror retractor switch, the outside rear-view mirrors automatically retract or extend when all the doors and tailgate are locked or unlocked using the remote control switches of the keyless entry system.

Refer to “Starting and driving: Outside rearview mirrors”.

• If the UNLOCK switch (2) is pressed and no door or tailgate is opened within approximately 30 seconds, relocking will automatically occur.

• It is possible to modify functions as follows:

For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.

On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.

• The time for automatic relocking can be changed.

• The confirmation function (flashing of the turn-signal lamps) can be set to operate only when the doors and backdoor are locked or only when the doors and backdoor are unlocked.

• The confirmation function (this indicates locking or unlocking of the doors and tailgate with the flash of the turn-signal lamps) can be deactivated.

• The number of times the turn-signal lamps are flashed by the confirmation function can be changed.

    See also:

    Selector lever position display screen*
    Shows the position of the selector lever. Refer to “Selector lever operation”. ...

    Wiper and washer switch
    CAUTION • If the washer is used in cold weather, the washer fluid sprayed against the glass may freeze, which may hinder visibility. Warm the glass with the defroster or rear window demister be ...

    Parking brake
    To park the vehicle, first bring it to a complete stop, fully apply the parking brake lever sufficiently to hold the vehicle. ...